Can I fill a 5000 gallon pool with my well

Several factors go into whether or not your well has the capacity of handing filling a swimming pool. It’s estimated at 540 gallons per hour, it will take about nine hours to fill a 5,000-gallon pool with a 1/2-inch hose. Most larger, in-ground pools are around 18,000-20,000 gallons.

Is it OK to fill a pool with well water?

As we said above, you can fill your swimming pool or hot tub with well water. In fact, it’s one of the least expensive options, especially compared to a pool water delivery service. … You’ll also need to test the water before using it in your pool, and you may have to treat it once it’s full.

How big is a pool that holds 5000 gallons of water?

Poolsize RoundCapacity (Gallons)Poolsize Oval12 Round3,0008×12,8×1415 Round5,00010×15, 10×1618 Round7,50010×21, 12×1821 Round10,00012×20, 12×21

When should I fill my pool with well water?

You will not run your well dry filling a pool unless the well has a low flow rate. If the flow rate of the well is lower than 150 gallons per hour, then you can run the well dry while filling a pool. Before you fill a pool with water from your well, you should check the well’s flow rate.

How fast does well water replenish?

Well water can replenish at a rate of 5 gallons per minute on average, but it will vary. It depends on the age of your well, how long you’ve been using it, the well’s location or geology, and the aquifer the well taps into to replenish its water level.

What is the cheapest way to fill a pool with water?

1. Your Water.
2. Call the water company and tell them you are going to fill your swimming pool. …
3. Run the hose to the pool with enough slack that the end of the hose is on the bottom of the pool.

How far does a pool need to be from a well?

How far should my pool be from the water? In most cases, we recommend building your pool at least 100 feet from any body of water.

How much water is in a typical well?

The typical 6-inch diameter well will hold approximately 1.5 gallons of water per foot of casing. The height of the water above the pump when it is not operating, multiplied by the gallons of water per foot of casing approximates the amount of available storage within the well casing.

Can well water make your pool green?

Your first instinct when you fill your pool with new water, is to shock it. But that shock then oxidizes the metals, that chemical reaction then causes the green hue in your water. This is common with refills that used well water or even water that hasn’t been shocked but instead contains a high level of metals.

What happens if my well runs dry?

When your well starts to run dry, you might notice reduced water pressure, sputtering faucets, and/or sediment in the water. The pump might run, but fail to draw water. It’s rare for a well to run dry permanently. … Doing so could damage the well and contaminate your water supply.

Article first time published on

Is it OK to fill a pool overnight?

Before adding any water to your pool, you should make sure that the pool is clean and free of any loose debris. If necessary, clean the pool so that you will have clean water right from the start. … It is never recommended to leave your home during this time or to fill your pool overnight.

How much chlorine does a 5000 gallon pool take?

6 ounces initially per 5,000 gallons and a a maintenance dose of . 75 ounces per 3,000 gallons every week. Initially you will need stabilizer to protect the chlorine from the sun.

How many hours does it take to fill a 5000 gallon pool?

Fill It Up If you upgraded to a 5/8-inch-diameter hose delivering 17 gallons per minute or 1,020 gallons per hour, you could fill your 5,000-gallon pool in about five hours.

How much shock do I need for a 5000 gallon pool?

Add liquid shock by pouring into skimmer with filter running (Liquid Shock is purchased separately, or is supplied with new pool package) at a rate of 1 gallon per 5000 gallons of pool water.

Can you refill a well?

In ideal conditions, a water well will refill at five gallons per minute. It takes two hours to fill a 600-gallon well. Not all wells exist under ideal conditions. There are several factors that can speed up or delay the time it takes to refill.

Does well water ever run out?

Well water will run out if the groundwater level drops below the water intake depth. This can be caused by natural or man-made variations in groundwater height including reduced precipitation, slow groundwater recharge, well infill, high water usage, well drawdown or hydrofracking.

Does rain fill your well?

YES! Rainfall has a direct impact on the local water table, which may immediately impact your residential well if it is supplied by shallow aquifers. … Your well may not ‘fill up’ when it rains, but it does reap the indirect benefits.

Can you build a pool over a well?

If you want to install an inground pool and you live in a home with a well and or a septic tank, yes an inground pool can be installed. … The water edge of the pool needs to be a certain distance away from the well or septic but in most cases; your pool patio would not have to be this distance away.

How far does an above ground pool have to be from a well?

National and Local Requirements There is a national standard that requires that all swimming pools must be at least 10 feet away from the house walls. As mentioned, this will protect electrical wiring from leaks, floods, and splashes.

How far does a pool need to be from a leach field?

Installing an inground pool has greater restrictions and will probably need to be installed at least 15 to 25 feet away from the septic tank or leach lines, depending on your county’s code requirements.

Is it cheaper to fill a pool with a hose?

Using that simple math, it stands to reason that your water bill will at least double when you fill your pool for the first time from a hose. For just a few more pennies per gallon, you could enjoy more time splashing with the family and alleviate any hassle associated with the task at hand.

How can I get my pool filled with water?

1. #1. Garden hose using city water. The most straightforward way to fill inground swimming pools with water is to connect a garden hose to your outdoor spigot. …
2. #2. Water delivery service. …
3. #3. Well. …
4. #4. Fire hydrant using city water.

Can you buy water to fill a pool?

Believe it or not, you can get pool water delivered, almost as easily as ordering from Amazon. There are companies that will bring a tank of water to your house, and use high-capacity hoses to fill your pool quickly.

Why did my pool turn green after I added chlorine?

The most common metals in swimming pools are copper and iron. … Copper in particular is the most problematic metal in a swimming pool, and it will turn to light green when chlorine is added. When any heavy metal is oxidized by chlorine, your swimming pool water, and parts will discolor as a result of metal stain.

How long after adding chemicals Can you swim?

It is recommended to wait at least 20 minutes to an hour after adding water balancing chemicals. You should wait 2-4 hours (or one full cycle through the filter) to swim from the moment you use calcium chloride in your pool. It is safe to swim once your chlorine levels are around 5 ppm or after 24 hours.

Why did my pool water turn green after I shocked it?

When shock chlorine oxidizes the copper, it turns green and that’s what you’re seeing in the pool. To get rid of it you’ll need to raise the pool’s calcium hardness by adding calcium chloride. The other culprit can be high levels of pollen.

How deep is a well for water?

In general, private home wells tend to range from 100 to 500 feet in depth. However, they can be much deeper than this in some cases. There are even some wells that go past the 1,000 foot mark. The average well depth in your area will depend on several factors.

How deep should a well be for drinking water?

For drinking water wells it’s best to be at least 100 feet deep so that surface contaminants cannot enter the well. The average well depth for private homes is between 100 to 800 feet [2]. You may need a deeper or shallower well if your area has different geology than another region of the country.

How do I increase my well yield?

Inadequacies in the well water yield can also be compensated for by increasing the amount of water stored within the water system. Added storage can be achieved in a pressure tank, a large storage tank (intermediate storage) or in the drilled borehole.

What is a good recovery rate for a well?

Typical numbers for well recovery rates (if measured honestly over a 24-hour period) run from a fraction of a gallon per minute (a terribly poor well recovery or flow rate) to 3 gallons a minute of water flow (not great but usable) to 5 gallons per minute (just fine for residential use) to more than 10 gpm (a great …

Does well water need to be filtered?

There are more than 15 million homes with well water in the United States, and it is generally safe to use and consume. … Well water almost always requires some softening and filtration to make it ideal for drinking, cooking, and cleaning.